"HASCO" tag

New HASCO nameplate editor facilitates customised designs

Speed, coupled with simple, efficient processes, are important in plastic injection moulding production. Tidiness and rapid identification of the available moulds are a key aspect here. Clear labelling with securely fixed nameplates helps…

HASCO has extended its range of proven latch locking units

HASCO has extended its range of proven latch locking units by an innovative, compact variant that can be mounted on the inside – the round latch locking unit Z1790/… . Internally mounted latch…

Hasco launches new products to speed mould development

Hasco Hasenclever, the german mould tooling components producer, has introduced three new products, including the H4016/, a fully assembled and wired hot-runner system that is ready to install. The robust connection between the hot runner…

New HASCO flat ejectors with two or four corner radii

Flat ejectors are the preferred type of ejector for areas of injection moulds that are critical from the design angle, such as ribs or bars. The new HASCO flat ejectors are noted for…

New, innovative adjustment plates from HASCO

When designing injection moulds, it is important to pay attention to achieving a defined distribution of the clamping pressure over the mould parting surfaces. The main surface pressure should always act close to…

Hasco extends its products portfolio

Hasco has increased itsproduct range with more than 500 new variants of existing standard components and accessories that adds to the 25 product groups in the company’s product range, reaching more than 100,000 individual parts. Mouldmakers can…

Hasco lauches goHasco, the new mouldmaking portal

The new Hasco mouldmaking portal has been developed in consultation and close cooperation with its customers to simplify mouldmaking, in the digital field too. At www.hasco.com, users worldwide can access the online shop…

Hasco extends its products portfolio

Hasco has increased its product range with more than 500 new variants of existing standard components and accessories that adds to the 25 product groups in the company’s product range, reaching more than…

New Mould Memory A5800 from Hasco

Mould Memory A5800 is the new mold memory information storage for use directly in the mold developed by Hasco Hasenclever GmbH + Co. KG. A special design allows flush-mounting directly in the mold,…

Hasco is launching a mold memory unit

Hasco is introducing a mold memory unit that stores all the information about the mold directly in the mold and a compact hot runner system. The Mold Memory A5800 is permanently installed in…

Mould&Die World magazine © 2024 All Rights Reserved